Solutions to common failures of water tower in water cooled high and low temperature impact test chamber

The important part of the water-cooled high and low temperature impact test chamber is the water tower, but when the operator uses it improperly, it will cause malfunctions. Next, the ring instrument will share with you its solutions.

 If the motor is overloaded, the voltage of the water-cooled high and low temperature impact test chamber may drop to too low, check the power supply and adjust it.

During noise and vibration, if the fan is not installed properly, the fan needs to be reinstalled. When the water droplets splash excessively, the water spray pipe will rotate too fast and the heat dissipation material will be blocked. If the water-cooled high and low temperature impact test chamber water baffle fails, the angle of the water spray pipe should be adjusted to eliminate the blockage of the heat dissipation material. Then replace the water stopper again.

When the temperature of the cooling water of the water-cooled high and low temperature impact test chamberincreases, the air volume is uneven. When the air is recirculated, when the heat dissipation material blocks the spray pipe, a better way is to improve the ventilation environment, and then Eliminate the blocked area of the heat sink, remove dirt and algae.

The above is all the contents of the ring instrument to share with you the solutions to common failures of the water-cooled high and low temperature impact test chamber water tower.