Requirements for the installation site of the high and low temperature test chamber

Although the temperature of the high and low temperature test chamber is not very high, the heat dissipation of the high and low temperature test chamber is still the first place. These environmental requirements are also applicable to other drying equipment: such as blast drying ovens, vacuum drying ovens, etc.

The place where the high and low temperature test chamber equipment is installed must meet the following conditions:

1. The ambient temperature of the installation site should not change too much. The large temperature difference between cold and hot is bound to affect the high temperature box.

2. Keep away from the wall or other objects as much as possible when placing it, and the distance should be about 50cm.

3. In order to give full play to the performance and functions of the high and low temperature alternating box, we should choose a place where the temperature is 15-25 degrees and the humidity cannot be greater than 85%, and it is best to place it in an environment with good ventilation.

4. Some customers say that the equipment is a bit noisy, so we should consider whether the equipment is on a level surface, and the equipment should not be tilted too much when placed, because uneven force will affect the use.

5. The equipment should not be exposed to the sun. Long-term exposure will make the temperature of the cabinet shell too high.

6. Keep away from combustibles, explosives, chemicals, and high-temperature heat sources, which may cause safety hazards.

7. Try to place it in a place with little dust. If there is too much dust, it will adhere to the parts. For example, if there is too much dust on the fan, it will not operate well. A series of things will affect the temperature uniformity in the high and low temperature test chamber and the use of the fan. life.

8. The power plug should not be too far away, because the length of the power cord of the high and low temperature test chamber is limited, and long-term pulling will short-circuit the internal pipeline of the power cord.