Installation process of swing pipe of IPX34 rain test chamber

The IPX34 rain test chamber is a typical instrument commonly used in waterproof testing equipment. It is mainly used to test the IPX3/4 waterproof level of the product. The IPX34 rain test box is sprayed through the swing pipe to spray the surface of the sample. Test (therefore called the swing tube rain tester in the industry). After the device is tested, the waterproof level that can be achieved is IPX3/IPX4 (depending on the experimental conditions). How to install the swing pipe installation process of the IPX34 rain test chamber?

The swing tube rain test machine is divided into open type and box type according to the model.

Among them, the box-type rain test chamber can realize cyclic rain test, and the water circuit is a closed loop, which can be directly reused. However, the water path of the open swing tube rain test machine is not recycled, so there are higher requirements for the use environment of this model. The following describes the installation conditions of the open rain shower.

Among them, the box-type rain test chamber can realize cyclic rain test, and the water circuit is a closed loop, which can be directly reused. However, the water path of the open swing tube rain test machine is not recycled, so there are higher requirements for the use environment of this model. The following describes the installation conditions of the open rain shower.

The swing tube rain tester is suitable for small samples. If it is a large sample, it needs to do an IPX34 waterproof test, that is, a shower rain test device is required. The shower rain test device is for comparison of large samples in all directions it is good.

The following editor of Coside Instruments lists the installation process of the IPX34 rain test chamber pendulum tube:

1. The main cabinet and auxiliary cabinet of the rain test machine should be placed in the same horizontal position with a distance of a swing pipe in between.

2. Install the gasket in the middle of the swing pipe position of the auxiliary cabinet

3. The water inlet of the swing pipe of the rain test machine should be aligned with the fixed position of the auxiliary cabinet

4. After correcting the position of the swing tube, tighten the bolts on both sides

5. Fix the casters of the main cabinet and the auxiliary cabinet.

6. The swing tube of the rain test machine should be aligned in the middle and vertical.

7. Check the angle of the swing tube of the rain test machine, and it has not been reset to zero. Adjust it according to the operation manual.

The size of the swing tube of the IPX34 rain test chamber is different (mainly to adapt to electronic and electrical products of different sizes).

The minimum standard size is R200mm, which is suitable for testing small home appliances (such as shavers, charging sockets, power switches, etc.), smart products (such as small Bluetooth headsets, Bluetooth speakers, mobile phones, tablets, etc.), and industrial appliances such as connectors, vernier calipers, etc. Accessories. The largest standard size is R1600mm, which is mainly suitable for testing large industrial products (such as communication cabinets, cable boxes, indoor control machines, etc.).