How to use the "high and low temperature alternating test chamber"

How to operate the high and low temperature alternating test box? In fact, the high and low temperature alternating test box is the same as the high and low temperature box. The high and low temperature is the more popular equipment in the environmental testing equipment industry. Its main function is to simulate the temperature and humidity environment for the product and then test it, and then improve Product quality issues.

Many users said: I don’t know much about this device, what should I do if I buy it and I can’t use it? In fact, don’t worry about this problem, because each manufacturer will provide the device with an instruction manual, which will not only record it. The use of constant temperature and humidity testing machine, such as later maintenance, cleaning, maintenance of some minor problems, etc. will be explained in detail above.

Our company will not only provide you with instructions for the high and low temperature test chambers, but the engineers will also teach you some basic operating problems during the on-site commissioning. Today, the editor mainly explains not the use of equipment, but some problems that need to be paid attention to when using the constant temperature and humidity testing machine.

The high and low temperature alternating test chamber must be connected to a power supply with a stable voltage of 380V, and this power supply is very dangerous for us, and exposure to it may cause serious injury or direct death.

Therefore, in order to avoid such safety accidents, check the usage of the power cord before each test. If it is worn or disconnected, it needs to be replaced in time. In addition, in order to prolong the service life of the power cord of the test chamber, try to pay more attention not to crush or step on the power cord too much during use.

This is the end of the introduction to the use of the high and low temperature alternating test chamber, and there are some noticeable issues that I will explain to you after the editor finishes finishing.